A practical reference on pineal peptides: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
Reviewed 2026-07-31. Anything still debated is marked as such rather than presented as settled.
Epitalon is a synthetic four-amino-acid peptide with the sequence alanine-glutamate-aspartate-glycine, commonly abbreviated AEDG. Its molecular formula is C14H22N4O9, and its calculated molar mass is approximately 390.35 grams per mole. The compound is a short fragment related to a peptide fraction isolated from bovine pineal gland extracts, and it is normally supplied as a lyophilised powder intended for laboratory research. It is not a registered pharmaceutical product in most countries.
The peptide emerged from research carried out in Saint Petersburg from the late 1980s onward, where investigators searched for shorter active fragments of a pineal preparation known as epithalamin. The name epitalon was chosen to reflect that parent extract. Early reports described effects on neuroendocrine markers and on the lifespan of laboratory animals. Much of that work appeared in Russian-language journals, with English translations following later, which affects how readily the original protocols can be assessed by outside groups.
Short peptides such as AEDG are normally supplied as a freeze-dried solid and are kept dry, cold, and shielded from light. Holding at minus twenty degrees Celsius is common for the long term, while a refrigerator suffices for brief periods before use. The material takes up moisture to some degree, so containers should stay sealed and be allowed to reach room temperature before opening, which limits condensation on the contents. Repeated warming and cooling of a single container is discouraged because it admits water and can lower the amount of intact peptide.
Dissolution is usually performed in water or a suitable aqueous buffer, and the resulting liquid is divided into single-use portions before freezing. Freeze-thaw cycling is a recognised source of loss for short peptides, since each cycle can encourage aggregation or adsorption onto container walls. Working solutions are generally kept cold and used within a short window, although published stability data specific to epitalon are thin. Containers should be marked with concentration and date, and solutions examined for cloudiness before use.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C14H22N4O9 | Derived from the four-residue sequence |
| Molar mass | About 390.35 g/mol | Free peptide, counter-ion not included |
| Appearance | White to off-white powder | Lyophilised solid from aqueous solution |
| Water solubility | Freely soluble | Short, polar peptide chain |
| Common synonyms | AEDG; epithalone | Catalogues use the names interchangeably |
Epitalon is the common name for a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, usually abbreviated AEDG. All four residues are proteinogenic amino acids, and the free peptide has a calculated mass near 390 grams per mole. Because the chain is short and carries no modifications, it is assembled readily by solid-phase synthesis and is distributed mainly as a freeze-dried solid for laboratory work. Catalogue listings use the spellings epitalon, epithalone, and simply AEDG, and the three refer to the same sequence.
The compound is generally presented as a synthetic fragment of epithalamin, a pineal gland extract investigated in the former Soviet Union from the 1970s onward. Vladimir Khavinson and colleagues in Saint Petersburg developed short peptides modelled on such extracts, and epitalon became the most widely cited of those sequences. Most primary reports appeared in Russian-language journals or in proceedings with limited international circulation. Independent replication in laboratories outside that network remains sparse, and much repeated secondary material traces back to a small number of originating groups.
Solubility is high in water, phosphate-buffered saline and normal saline, a pattern that follows from the two acidic residues in the chain. The peptide dissolves poorly in non-polar solvents such as hexane or chloroform. Stock solutions are often prepared in water first and then diluted into the buffer of interest. Because the molecule is small and hydrophilic, filtration through a low-protein-binding membrane is usually straightforward, and visible particulates are uncommon in freshly made solutions.
Identity and purity are established with reversed-phase high-performance liquid chromatography and mass spectrometry. The chromatogram shows the main peak and any truncated or oxidised by-products, while the mass spectrum confirms the expected 390 dalton mass. Amino acid analysis can corroborate composition when a sample's origin is uncertain. Counterion content, particularly residual trifluoroacetate from purification, is frequently reported alongside purity because it shifts the net mass of the solid.
The enterprise viewpoint, which focuses on the purpose, scope and policies for the system. It describes the business requirements and how to meet them. The information viewpoint, which focuses on the semantics of the information and the information processing performed. It describes the information managed by the system and the structure and content type of the supporting data. The computational viewpoint, which enables distribution through functional decomposition on the system into objects which interact at interfaces. It describes the functionality provided by the system and its functional decomposition. The engineering viewpoint, which focuses on the mechanisms and functions required to support distributed interactions between objects in the system. It describes the distribution of processing performed by the system to manage the information and provide the functionality. The technology viewpoint, which focuses on the choice of technology of the system. It describes the technologies chosen to provide the processing, functionality and presentation of information.
The split and pool synthesis (S&P synthesis) differs from traditional synthetic methods. The important novelty is the use of compound mixtures in the process. This is the reason of its unprecedentedly high productivity. Using the method one single chemist can make more compounds in a week than all chemists produced in the whole history of chemistry. The S&P synthesis is applied in a stepwise manner by repeating three operations in each step of the process:
== Alternatives to medication == Cognitive behavioral therapy (CBT) is an effective treatment for panic disorder, social anxiety disorder, generalized anxiety disorder, and obsessive–compulsive disorder, while exposure therapy is the recommended treatment for anxiety related phobias. Healthcare providers can guide those with anxiety disorder by referring them to self-help resources. Sometimes medication is combined with psychotherapy but research has not found a benefit of combined pharmacotherapy and psychotherapy versus monotherapy. If CBT is found ineffective, both the Canadian and American medical associations then suggest the use of medication.
Sources: en.wikipedia.org
The antagonist has a peptide moiety. The nomenclature of the somatostatin receptor antagonists is also based on this order. The structure of somatostatin receptor antagonists are similar to that of the agonists. Some agonists were already approved by the FDA for clinical use, such as In-DTPA-octreotide and Ga-DOTATATE. Development started after the discovery of modifications that can be done to the octreotide group, a ssrt selective subtype agonist, to cause its agonistic effects to be lost and gain antagonistic effects. Different subtype receptor antagonists were later developed. Research has mostly been done on the sstr2 receptor antagonist, as the sstr2 receptor is expressed on most tumors. Somatostatin receptor antagonists are divided by generation based on the type of the subtype receptor antagonist. The first generation consists of sst2-ANT and BASS, which are sstr2 selective; and sst3-ODAN-8, which is selective for sstr3. After initial results of their increased sensitivity to neurocrine tumors appeared, ssrt2 selective antagonists that had even higher affinity were developed. These were LM3, JR10, and JR11, which make up the second generation. JR11 was shown to be the most effective among these 3 antagonists, and compounds that entered further clinical development to act as a PET imaging agent or therapeutic agent carried this subtype antagonist. The presence of a chelator coupled to the subtype antagonist was shown to have an effect on the biologic properties. Compounds were developed with 3 macrocyclic chelators: DOTA, NODAGA, and CB-TE2A.
The properties of a hydrogel are highly dependent on the type and quantity of its crosslinks, making photopolymerization a popular choice for fine-tuning hydrogels. This technique has seen considerable use in cell and tissue engineering applications due to the ability to inject or mold a precursor solution loaded with cells into a wound site, then solidify it in situ. Physically crosslinked hydrogels can be prepared by different methods depending on the nature of the crosslink involved. Polyvinyl alcohol hydrogels are usually produced by the freeze-thaw technique. In this, the solution is frozen for a few hours, then thawed at room temperature, and the cycle is repeated until a strong and stable hydrogel is formed. Alginate hydrogels are formed by ionic interactions between alginate and double-charged cations. A salt, usually calcium chloride, is dissolved into an aqueous sodium alginate solution, that causes the calcium ions to create ionic bonds between alginate chains. Gelatin hydrogels are formed by temperature change. A water solution of gelatin forms an hydrogel at temperatures below 37–35 °C, as Van der Waals interactions between collagen fibers become stronger than thermal molecular vibrations.
homoserine + NAD(P)+ Homoserine represents another branch in the aspartate pathway, as it can progress down one of two pathways to eventually become one of two amino acids: threonine or methionine. This aspartate pathway is present in plants and bacteria, allowing them to synthesize lysine, methionine, and threonine. This pathway is not present in humans or other animals, however. The lack of this pathway means that humans need to take in these amino acids through their diet, which is why they are called essential amino acids.
Sources: en.wikipedia.org
=== Single-locus sequence typing === Single-locus sequence typing (SLST) is the sequencing of a single locus of an organism to produce data that can be used for strain-level comparisons between isolates of the same species.
== Function == Androgens that bind to and activate the androgen receptor have numerous physiological functions which can broadly divided into androgenic (male sexual development) and anabolic (building muscle and bone). The anabolic effects are important in both males and females, although females have lower circulating levels of androgens. The physiologically most important androgens are testosterone (T) and dihydrotestosterone (DHT), which are considered classical androgens because their role in human health was discovered in 1930s. However, much later, in 2010s, the role in human health of 11-oxygenated androgens was established, namely, of 11-ketotestosterone (11KT) and 11-ketodihydrotestosterone (11KDHT), that both bind and activate the human androgen receptor with affinities, potencies, and efficacies that are similar to that of testosterone (T) and DHT, respectively, although 11-oxygenated androgens were long known to be principal androgens in teleost fishes. The main biochemical route to T and DHT is the canonical (classical) pathway that proceeds from pregnenolone (P5). Alternatively, DHT but not T can be produced through a backdoor pathway that proceeds from 17α-hydroxyprogesterone (17OHP) or progesterone (P4). The function of androgen backdoor pathways is to produce physiologically significant androgens in normal conditions where the conventional pathway is insufficient, such as in male early sexual differentiation. Sexual differentiation is a process by which hormones determine anatomic phenotype, mainly the development of the reproductive organs.
== Further reading == Gibbon, G.A. (1996). "A brief history of LIMS". Laboratory Automation and Information Management. 32 (1): 1–5. doi:10.1016/1381-141X(95)00024-K. Veterinary Lab Management Software Market Analysis
== Interactions == Trimipramine should not be given with sympathomimetic agents such as epinephrine (adrenaline), ephedrine, isoprenaline, norepinephrine (noradrenaline), phenylephrine and phenylpropanolamine. Barbiturates may increase the rate of metabolism. Trimipramine should be administered with care in patients receiving therapy for hyperthyrodism.
Sources: en.wikipedia.org
It is a synthetic tetrapeptide built from alanine, glutamate, aspartate and glycine. The four residues are joined by standard peptide bonds, giving a linear chain rather than a branched structure.
The name derives from epithalamin, a pineal gland extract studied in the former Soviet Union. Researchers proposed that short fragments of that extract carried the biological activity of interest.
No major regulatory agency has approved it as a medicine. It is handled as a research chemical, and products sold under this name are not standardised drugs with defined clinical labelling.
Reversed-phase high-performance liquid chromatography is run alongside mass spectrometry. The chromatogram separates components and gives a purity figure, while the mass spectrum confirms that the measured molecular mass matches the expected sequence. Neither measurement on its own is treated as sufficient.