en · de · es · pt
epitalon-notes.peptides7250.com › Data › Peptide Identity And Laboratory Handling — Explained

Peptide Identity And Laboratory Handling — Explained

By Editorial Desk · published 2026-02-20 · last reviewed 2026-03-15 · Data

If you have been reading about Epitalon and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.

Updated 2026-03-15. Numbers and descriptions here follow the published literature rather than marketing material.

Peptide Identity and Laboratory Handling

Epitalon is a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and its calculated monoisotopic mass is approximately 390.35 daltons. The compound does not occur naturally as a free peptide; it is produced by solid-phase peptide synthesis. Because it contains two acidic residues and no basic residues, the neutral form carries a net negative charge at physiological pH. This charge profile influences how the peptide behaves in solution and during chromatographic analysis.

Laboratory-grade epitalon is typically supplied as a lyophilized powder. Purity is commonly assessed with reverse-phase high-performance liquid chromatography, often paired with mass spectrometry to confirm molecular identity. Amino acid analysis and peptide mapping can provide additional confirmation of sequence. Certificates of analysis for research materials frequently report purity above 95 percent, although the methods behind such figures vary between suppliers. The absence of a pharmacopeial monograph means that no single standardized assay defines the compound, so reported results depend on the analytical protocol chosen.

Storage recommendations center on limiting moisture, heat, and light. The dry powder is generally kept at minus 20 degrees Celsius, and some suppliers recommend minus 80 degrees for long-term archival. Once dissolved, solutions are usually aliquoted and frozen to avoid repeated freeze-thaw cycles, which can promote aggregation or degradation. Aqueous stability depends on pH and concentration, and buffered saline is often preferred over plain water for biological work. Stability data specific to epitalon remain limited, so general peptide-handling practices are applied by analogy rather than from product-specific validation.

Structure, Naming and Discovery

Epitalon is a synthetic tetrapeptide whose four residues are alanine, glutamate, aspartate and glycine, commonly abbreviated AEDG. Its molecular formula is C14H22N4O9 and its monoisotopic mass is near 390.35 daltons. The peptide carries two acidic side chains, so it is neutral to negatively charged in most aqueous buffers. Published reference summaries usually list it under both spellings, epitalon and epithalon, and treat the two names as the same material.

The compound is generally described as a synthetic analogue of a fragment isolated from a pineal gland extract. Researchers associated with the Saint Petersburg Institute of Bioregulation and Gerontology introduced it during the 1980s and 1990s while studying short peptides from animal tissue. The original extract, called epithalamin, is a heterogeneous mixture, whereas epitalon is a single defined sequence. That distinction matters because findings reported for the extract are not automatically findings about the pure tetrapeptide, and claims about broader biological effects remain a separate question from the chemical identity described here.

Epitalon at a glance

PropertyValueNotes
Molecular formulaC14H22N4O9Free acid form of the tetrapeptide
Molecular massAbout 390.35 DaCalculated monoisotopic value
AppearanceWhite to off-white powderTypical lyophilized presentation
SolubilitySoluble in waterAlso dissolves in buffered saline
Storage temperatureMinus 20 degrees CelsiusDry, dark conditions; avoid repeated thawing

Peptide Identity and Research Origin

Epitalon is a synthetic tetrapeptide with the sequence alanine–glutamate–aspartate–glycine, commonly abbreviated AEDG. Its design traces to epithalamin, a peptide fraction prepared from bovine pineal gland extracts that researchers in Saint Petersburg began investigating in the 1970s. The compound has a molecular formula of C14H22N4O9 and a nominal molecular mass near 390 daltons. It holds no approved drug status in the United States or the European Union, and material sold under this name is generally offered as a research chemical rather than a finished pharmaceutical product.

Proposed mechanisms centre on cell-culture observations rather than a defined receptor interaction. Several reports describe increased expression of the telomerase catalytic subunit after exposure of cultured human cells, and the authors attributed the effect to short peptide fragments entering the nucleus and influencing gene transcription. No receptor for the tetrapeptide has been identified, and the free peptide is expected to be degraded rapidly by plasma peptidases. Whether any measurable fraction reaches intact tissues after administration remains an unresolved question rather than an established finding.

Related pages on this site

Supporting material

== Uniformity == The chemical processing and synthesis of high performance technological components for the private, industrial and military sectors requires the use of high purity ceramics, polymera, glass-ceramics, and composite materials. In condensed bodies formed from fine powders, the irregular sizes and shapes of nanoparticles in a typical powder often lead to non-uniform packing morphologies that result in packing density variations in the powder compact. Uncontrolled agglomeration of powders due to attractive van der Waals forces can also give rise to in microstructural inhomogeneities. Differential stresses that develop as a result of non-uniform drying shrinkage are directly related to the rate at which the solvent can be removed, and thus highly dependent upon the distribution of porosity. Such stresses have been associated with a plastic-to-brittle transition in consolidated bodies, and can yield to crack propagation in the unfired body if not relieved. In addition, any fluctuations in packing density in the compact as it is prepared for the kiln are often amplified during the sintering process, yielding inhomogeneous densification. Some pores and other structural defects associated with density variations have been shown to play a detrimental role in the sintering process by growing and thus limiting end-point densities. Differential stresses arising from inhomogeneous densification have also been shown to result in the propagation of internal cracks, thus becoming the strength-controlling flaws.

== Release == In June 2013, the U.S. distribution rights for That Awkward Moment were acquired by FilmDistrict with a wide release set for January 31, 2014. Because of a transition of FilmDistrict properties to Focus Features, That Awkward Moment was later absorbed by the reconstituted Focus Features for its January 2014 release. The first red band trailer was released on October 14, 2013.

These pathways are also important in environmental science, with the xenobiotic metabolism of microorganisms determining whether a pollutant will be broken down during bioremediation, or persist in the environment. The enzymes of xenobiotic metabolism, particularly the glutathione S-transferases are also important in agriculture, since they may produce resistance to pesticides and herbicides.

Sources: en.wikipedia.org

Supporting material

=== Preclinical === 2-Bromo-LSD (bromolysergide; BOL-148; BETR-001, TD-0148A) – non-hallucinogenic serotonin 5-HT2A receptor agonist and other actions ART-2612 (ART2612) – FABP5 inhibitor [25] BMB-202 – serotonin 5-HT2A receptor agonist [26] Cycloserine/lurasidone (NRX-101) – combination of cycloserine (NMDA receptor partial agonist) and lurasidone (atypical antipsychotic or non-selective monoamine receptor modulator) [27] Cyproheptadine/prazosin (KT-110; Periactine/Alpress) – combination of cyproheptadine (H1 receptor antagonist, muscarinic acetylcholine receptor antagonist, serotonin receptor antagonist, other actions) and prazosin (α1-adrenergic receptor antagonist) [28] GM-3009 (ibogaine analogue(s); GMX-3009) – various actions Leu-enkephalin (leucine enkephalin; Envelta; METDoloron; NES-100; NM-0127; NM-127; PES200) – δ-opioid receptor agonist [29] Metyrapone/oxazepam (EMB-001C; EMB-001) – combination of metyrapone (11β-hydroxylase inhibitor, antiglucocorticoid) and oxazepam (GABAA receptor positive allosteric modulator, benzodiazepine) Midomafetamine microneedle transdermal patch (MDMA; "ecstasy") – serotonin–norepinephrine–dopamine releasing agent, weak serotonin 5-HT2 receptor agonist, and entactogen NB-127 – undefined mechanism of action [30] NNI-351 – DYRK kinase inhibitor, nerve growth factor (NGF) stimulant [31] Prabotulinumtoxin A (ABP-450; DWP-450; Evosyal; Jeuveau; Nabota; Nuceiva) – acetylcholine release inhibitor and neuromuscular blocking agent [32] Research programme: neurotransmitter modulators - Awakn Life Sciences (AWKN-SDN-14) – serotonin–norepinephrine–dopamine reuptake inhibitors [33] TN-001 – non-hallucinogenic serotonin 5-HT2A receptor partial agonist and serotonin 5-HT2B receptor antagonist and neuroplastogen

== Purpose == Pharmacokinetics simulation gives an insight to drug efficacy and safety before exposure of individuals to the new drug that might help to improve the design of a clinical trial. Pharmacokinetics simulations help in addition in therapy planning, to stay within the therapeutic range under various physiological and pathophysiological conditions, e.g., chronic kidney disease.

Bariatric surgery ("weight loss surgery") is the use of surgical intervention in the treatment of obesity. As every operation may have complications, surgery is only recommended for severely obese people (BMI > 40) who have failed to lose weight following dietary modification and pharmacological treatment. Weight loss surgery relies on various principles: the two most common approaches are reducing the volume of the stomach (e.g. by adjustable gastric banding and vertical banded gastroplasty), which produces an earlier sense of satiation, and reducing the length of bowel that comes into contact with food (e.g. by gastric bypass surgery or endoscopic duodenal-jejunal bypass surgery), which directly reduces absorption. Band surgery is reversible, while bowel shortening operations are not. Some procedures can be performed laparoscopically. Complications from weight loss surgery are frequent. Surgery for severe obesity is associated with long-term weight loss and decreased overall mortality. One study found a weight loss of between 14% and 25% (depending on the type of procedure performed) at 10 years, and a 29% reduction in all cause mortality when compared to standard weight loss measures. A marked decrease in the risk of diabetes mellitus, cardiovascular disease and cancer has also been found after bariatric surgery. Marked weight loss occurs during the first few months after surgery, and the loss is sustained in the long term.

Sources: en.wikipedia.org

Frequently asked questions

What is epitalon made of?

Epitalon is a synthetic tetrapeptide built from four amino acids: alanine, glutamate, aspartate, and glycine. It is not extracted from a natural source but made in the laboratory by chemical synthesis. Its short length makes it relatively straightforward to produce at high purity.

Does epitalon occur naturally in the body?

No naturally occurring free form of the peptide has been described. The four-amino-acid sequence can appear as a fragment within larger proteins, but that is not the same as the intact compound being present as a circulating molecule. Materials used in research are synthetic.

How is epitalon purity checked?

Purity is usually checked by reverse-phase high-performance liquid chromatography, which separates the target peptide from related impurities. Mass spectrometry is commonly used alongside it to confirm molecular mass. Some suppliers also provide amino acid analysis for additional sequence confirmation.

What is epitalon made of?

It is a four-amino-acid peptide built from alanine, glutamate, aspartate and glycine in that order. Its formula is C14H22N4O9, and it is made by chemical synthesis rather than extracted from tissue. The synthetic peptide is a single defined molecule, unlike the pineal extracts it is often compared with.

Network